Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
- 10. Brake system
   + 10.1.2. Shock-absorbers
   + 10.2. Technical characteristics
   10.3. Pumping of hydraulic system
   10.4. Hydraulic tubes and hoses
   10.5. Brake overlays of forward brakes
   10.6. Brake overlays of back wheels
   10.7. Brake shoes of back brakes
   10.8. Brake disk of a forward wheel
   10.9. Brake disk of a back wheel
   10.10. Brake drum of a back brake
   10.11. Support of a forward brake
   10.12. Support of a back brake
   10.13. Wheel cylinder of a back brake
   10.14. Main brake cylinder
   10.15. Brake pedal
   10.16. Vaakuumny amplifier
   10.17. Vacuum valve of a servoamplifier
   10.18. Rope of the hand brake
   10.19. Lever of the hand brake
   10.20. The valve of adjustment of pressure in a contour of back brakes (to 96 g of century)
   10.21. Switch of fires of a stoplight
   10.22. General description of system of anti-blocking of brakes (ABS)
   10.23. ABS system elements
   10.24. Vacuum pump (diesel and petrol engines in volume of 2,3 l)
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

10.7. Brake shoes of back brakes

GENERAL INFORMATION

Elements of a back drum-type brake

1. Klinyshek
2. Pusher
3. Forward brake shoe
4. Spring
5. Top returnable spring
6. Cap
7. Lever manual томоза
8. Bottom returnable spring
9. Wheel cylinder
10. Guard
11. Cap
12. Back brake shoe
13. Spring

Replacement

PERFORMANCE ORDER
1. Remove a brake drum.
2. Clear the brake mechanism of an asbestine dust (see fig. Elements of a back drum-type brake).
3. Examine brake shoes and measure thickness of a frictional material. For replacement of brake shoes mark the provision of installation of blocks and springs.
4. Remove caps and clamping springs.
5. Remove pins of clamping springs of blocks.
6. Remove the bottom returnable spring.
7. Remove brake shoes. Put on an elastic band (shooter) the wheel cylinder for fixing of pistons.
8. Mark the provision of installation of all springs (arrow) and remove them.
9. Installation of brake shoes is carried out upside-down removals.