Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
- 10. Brake system
   + 10.1.2. Shock-absorbers
   + 10.2. Technical characteristics
   10.3. Pumping of hydraulic system
   10.4. Hydraulic tubes and hoses
   10.5. Brake overlays of forward brakes
   10.6. Brake overlays of back wheels
   10.7. Brake shoes of back brakes
   10.8. Brake disk of a forward wheel
   10.9. Brake disk of a back wheel
   10.10. Brake drum of a back brake
   10.11. Support of a forward brake
   10.12. Support of a back brake
   10.13. Wheel cylinder of a back brake
   10.14. Main brake cylinder
   10.15. Brake pedal
   10.16. Vaakuumny amplifier
   10.17. Vacuum valve of a servoamplifier
   10.18. Rope of the hand brake
   10.19. Lever of the hand brake
   10.20. The valve of adjustment of pressure in a contour of back brakes (to 96 g of century)
   10.21. Switch of fires of a stoplight
   10.22. General description of system of anti-blocking of brakes (ABS)
   10.23. ABS system elements
   10.24. Vacuum pump (diesel and petrol engines in volume of 2,3 l)
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

10.24. Vacuum pump (diesel and petrol engines in volume of 2,3 l)

4-CYLINDER ENGINES

Removal

PERFORMANCE ORDER
1. The vacuum pump is established on the left side in a back part of the block of cylinders.
2. Disconnect a vacuum hose from the pump.
3. Will twist a fixing bolt and remove a fixing clip of the pump.
4. Remove the pump from the block of cylinders and remove a sealing ring.

Installation

PERFORMANCE ORDER
Installation is carried out upside-down removals. Check, that at installation the groove on a conducted gear wheel of the pump (shooter) was correctly combined with a leading gear wheel.

5-CYLINDER ENGINES

Removal

PERFORMANCE ORDER
1. The vacuum pump is established on the left side of a head of the block of cylinders.
2. Disconnect a vacuum hose from the pump.
3. Turn off fixing nuts.
4. Remove the pump and a pusher.
5. Remove a sealing ring.

Installation

Installation is carried out upside-down removals.

Check and repair

PERFORMANCE ORDER
1. By means of a vacuum manometer check, that the depression created by the pump, made at least 500 mm of a mercury column.
2. If the pump is faulty, it is necessary to replace it.