Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
- 3.3. Removal and partition of engines
   + 3.3.2. Technical characteristics
   3.3.3. Repair work, possible without engine dismantle
   + 3.3.4. Major maintenance
   3.3.5. Removal and engine installation
   3.3.6. Engine partition
   + 3.3.7. Head of cylinders
   3.3.8. Pistons and rods
   + 3.3.9. Cranked shaft
   3.3.10. Intermediate shaft
   3.3.11. Block of cylinders
   3.3.12. Radical bearings and bearings of rods
   3.3.13. Piston rings
   3.3.14. The first start of the engine after a partition
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c
Советы по строительству: https://dizidom.ru | Читаем о новом: https://myavto24.ru

3.3. Removal and partition of engines

3.3.1. Introduction

GENERAL INFORMATION

Prevention

All designs except 6-cylinder petrol engines are described.


In real subsection operations on major maintenance of the engine, including details of a head of the block of cylinders and the block of cylinders are considered. In subsection are included as the recommendations concerning as the organization and preparation of works on major maintenance of the engine, purchase of spare parts, and the detailed description of procedures of dismantle and installation of details of the engine, and also methods of check of a technical condition of details.

In the subsequent subsections it is meant that repair work is carried out after dismantle of the power unit from the car.

The specifications provided above are necessary only for check of a technical condition of details in procedures of repair described below.