Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
- 10. Brake system
   + 10.1.2. Shock-absorbers
   + 10.2. Technical characteristics
   10.3. Pumping of hydraulic system
   10.4. Hydraulic tubes and hoses
   10.5. Brake overlays of forward brakes
   10.6. Brake overlays of back wheels
   10.7. Brake shoes of back brakes
   10.8. Brake disk of a forward wheel
   10.9. Brake disk of a back wheel
   10.10. Brake drum of a back brake
   10.11. Support of a forward brake
   10.12. Support of a back brake
   10.13. Wheel cylinder of a back brake
   10.14. Main brake cylinder
   10.15. Brake pedal
   10.16. Vaakuumny amplifier
   10.17. Vacuum valve of a servoamplifier
   10.18. Rope of the hand brake
   10.19. Lever of the hand brake
   10.20. The valve of adjustment of pressure in a contour of back brakes (to 96 g of century)
   10.21. Switch of fires of a stoplight
   10.22. General description of system of anti-blocking of brakes (ABS)
   10.23. ABS system elements
   10.24. Vacuum pump (diesel and petrol engines in volume of 2,3 l)
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

10.18. Rope of the hand brake

Removal

PERFORMANCE ORDER
1. Disconnect a rope from the balance weight and get a rope braid from fastening.

2. Remove a rope braid from fastenings. Turn off a fixing nut.
3. Disconnect a rope from the lever of the hand brake and remove it from the car.

Installation

Installation is carried out upside-down removals.

Adjustment

PERFORMANCE ORDER
1. Turn off an adjusting nut of a rope of the hand brake to weaken a tension of ropes.

MODELS WITH BACK DRUM-TYPE BRAKES

PERFORMANCE ORDER
2. Squeeze out a brake pedal several times.
3. Lift the lever of the hand brake on three clicks.
4. Twirl an adjusting nut so that brake shoes began to concern brake drums. Release the hand brake and check, that wheels rotated freely.
5. Lift the lever of the hand brake on three clicks and check correctness of adjustment.

MODELS WITH BACK DISK BRAKES

PERFORMANCE ORDER

2. Check, that levers of the hand brake on supports of both back wheels concerned an emphasis.
3. Squeeze out a brake pedal several times to establish the correct gap between brake slips and a disk.
4. Twirl an adjusting nut of the hand brake so that levers of hand brakes slightly rose from an emphasis. Turn off an adjusting nut on two complete revolutions back.
5. Check, that both levers densely concerned an emphasis.
6. Check adjustment of the hand brake and repeat it if it is necessary.