Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
- 10. Brake system
+ 10.1.2. Shock-absorbers
+ 10.2. Technical characteristics
10.3. Pumping of hydraulic system
10.4. Hydraulic tubes and hoses
10.5. Brake overlays of forward brakes
10.6. Brake overlays of back wheels
10.7. Brake shoes of back brakes
10.8. Brake disk of a forward wheel
10.9. Brake disk of a back wheel
10.10. Brake drum of a back brake
10.11. Support of a forward brake
10.12. Support of a back brake
10.13. Wheel cylinder of a back brake
10.14. Main brake cylinder
10.15. Brake pedal
10.16. Vaakuumny amplifier
10.17. Vacuum valve of a servoamplifier
10.18. Rope of the hand brake
10.19. Lever of the hand brake
10.20. The valve of adjustment of pressure in a contour of back brakes (to 96 g of century)
10.21. Switch of fires of a stoplight
10.22. General description of system of anti-blocking of brakes (ABS)
10.23. ABS system elements
10.24. Vacuum pump (diesel and petrol engines in volume of 2,3 l)
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice
|
Prevention
On models from ABS disconnect the accumulator before the work beginning to prevent air hit in the ABS module.
Removal
| PERFORMANCE ORDER |
| 1. Uncover a tank of brake liquid. |
| 2. Disconnect a hose of the main cylinder of a drive of switching off of coupling and an ABS module hose (if it is necessary) and merge brake liquid. |
| 3. Disconnect the socket of connection of the sensor of level of brake liquid. |
| 4. Disconnect brake tubes from the main brake cylinder. |
| 5. Turn off two fixing nuts and remove the cylinder. |
|
Repair
| PERFORMANCE ORDER |
| 1. If the main brake cylinder is faulty, it is necessary to replace it. The unique element which is subject to replacement, plugs of a tank of brake liquid are. |
|
|
2. Check, that consolidation (And) was correctly established in a tube and acted from a reverse side approximately on 1 mm (measurement "and"). |
|
Installation
Installation is carried out upside-down removals.
|
|
