Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
- 12. Body
   12.2. Maintenance and repair
   12.3. Front bumper
   12.4. Rear bumper
   12.5. Cowl
   + 12.6. Rope of opening of a cowl
   12.7. Cowl lock
   12.8. Doors
   12.9. Internal panel of furnish of a door
   12.10. Frame of a window of a door
   12.11. Handle of a door and lock elements
   12.12. Glass and window regulator
   12.13. Trunk lid
   12.14. Elements of the lock of a trunk lid
   12.15. Back door
   12.16. Elements of the lock of a back door
   12.17. Elements of the central lock
   + 12.18. Elements of electric window regulators
   12.19. Rear-view mirrors and related elements
   12.20. Front and back glass
   12.21. Top hatch
   12.22. External elements of furnish of a body
   12.23. Sitting
   12.24. Mechanism of a tension of forward seat belts
   12.25. Elements of seat belts
   12.26. Panels of furnish of salon
   12.27. Central console
   12.28. Dashboard
+ 13. Electric equipment
+ 14. Good advice


ff85f19c
Обзор Carlsson MERCEDES ML CD35

12.10. Frame of a window of a door

Removal

PERFORMANCE ORDER
1. Remove the internal panel of furnish of a door.

2. Remove fixing clips, fastenings of wires and isolating panel.
3. On a back door disconnect a rope from the lock and lever button.
4. Disconnect the connection socket from the engine of a window regulator and remove wires from a door.
5. Mark the provision of installation of fixing bolts of a frame. Turn off fixing bolts and remove an adjusting wedge.
6. On a back door unbend consolidation and remove it together with a frame.

Installation

PERFORMANCE ORDER
1. Installation is carried out upside-down removals. On termination of installation adjust the provision of a frame and glass.
2. At installation check, that the adjusting wedge (4) was correctly established between a frame (1) and a door (2), and also that the forward bottom fixing bolt (3) passed through an opening in a wedge.
3. Check correctness of laying of wires and reliability of fastenings.
4. Establish a glass frame so that the distance (and) between an external edge of glass (3) and a decorative strip on a roof (1) was 6,5±1 mm (at the closed door) and consolidation (2) was a little compressed.
5. Adjust a uvula.
6. Adjust the plane of contact of glass and a rubber insert that the distance instead of exceeded a limit in 0,5–1,0 mm.
7. Adjust the screw in a range of 0,5-1,0 mm.