Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
- 12. Body
   12.2. Maintenance and repair
   12.3. Front bumper
   12.4. Rear bumper
   12.5. Cowl
   + 12.6. Rope of opening of a cowl
   12.7. Cowl lock
   12.8. Doors
   12.9. Internal panel of furnish of a door
   12.10. Frame of a window of a door
   12.11. Handle of a door and lock elements
   12.12. Glass and window regulator
   12.13. Trunk lid
   12.14. Elements of the lock of a trunk lid
   12.15. Back door
   12.16. Elements of the lock of a back door
   12.17. Elements of the central lock
   + 12.18. Elements of electric window regulators
   12.19. Rear-view mirrors and related elements
   12.20. Front and back glass
   12.21. Top hatch
   12.22. External elements of furnish of a body
   12.23. Sitting
   12.24. Mechanism of a tension of forward seat belts
   12.25. Elements of seat belts
   12.26. Panels of furnish of salon
   12.27. Central console
   12.28. Dashboard
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

12.16. Elements of the lock of a back door

Removal

PERFORMANCE ORDER
1. Remove the top panel of furnish (shooters showed fixing clips).
2. Remove lateral panels of furnish.
3. Turn off fixing screws on each side and from above the main panel of furnish.
4. Turn off the fixing screws located in deepening of the handle.
5. Remove the furnish panel.

LOCK

PERFORMANCE ORDER
1. Disconnect drafts and the connection socket from the lock.
2. Turn off fixing nuts (arrows) and remove the lock.

CASING OF THE DRUM OF THE LOCK

PERFORMANCE ORDER
1. Disconnect drafts from a lock drum. Disconnect the connection socket.
2. Turn off fixing nuts (arrows) and remove a lock drum.

DOOR HANDLE

PERFORMANCE ORDER
1. Remove the screen wiper engine.
2. Release fixing clips and disconnect drafts from the handle.
3. Turn off fixing bolts (shooters) and remove the handle.

Installation

Installation is carried out upside-down removals.
At installation use regulators (are specified by shooters) for adjustment of length of drafts.