Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 3.2. Diesel engines
   - 3.2.1.2. Technical characteristics
      3.2.1.3. Sinkhronizatsionnye of a gazoraspredeleniye label
      3.2.1.4. Compression check
      3.2.1.5. Gas-distributing belt
      3.2.1.6. Natyazhitel of a gas-distributing belt, asterisk
      3.2.1.7. Additional driving belts
      3.2.1.8. Camshaft cover
      3.2.1.9. Camshaft epiploon
      3.2.1.10. Epiploon of an intermediate shaft
      3.2.1.11. Epiploons of a cranked shaft
      3.2.1.12. Head of cylinders
      3.2.1.13. Hydraulic pushers
      3.2.1.14. Flywheel
      3.2.1.15. Engine fastenings
      3.2.1.16. Oil pallet
      3.2.1.17. Oil pump and maslozaborny branch pipe
   + 3.2.2. 5-cylinder engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

3.2.1.6. Natyazhitel of a gas-distributing belt, asterisk

NATYAZHITEL OF THE GAS-DISTRIBUTING BELT

Removal
PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove driving belts.
3. Establish the N1 piston in VMT and remove the top cover of a gas-distributing belt.
4. Weaken a nut of a natyazhitel and weaken a belt. Braid a nut.
5. Remove a natyazhitel.

Installation

PERFORMANCE ORDER
Establish a natyazhitel upside-down and pull a belt.

CAMSHAFT ASTERISK

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove driving belts.
3. Establish the N1 piston in VMT and remove the top cover of a gas-distributing belt.
4. Remove a natyazhitel and a belt.
5. Unscrew a bolt of an asterisk of a cranked shaft and remove an asterisk.

Installation

Installation is carried out upside-down removals.

ASTERISK OF THE CRANKED SHAFT

Removal
PERFORMANCE ORDER
1. Remove a gas-distributing belt.
2. Unscrew a bolt of an asterisk of a cranked shaft and remove an asterisk.

Installation

Installation is carried out upside-down removals.

PERFORMANCE ORDER
1. Insert a bolt of an asterisk of a cranked shaft.
2. Tighten a bolt till the demanded moment of an inhaling.
3. Tighten a bolt on a demanded corner.

ASTERISK OF THE INTERMEDIATE SHAFT

Removal

PERFORMANCE ORDER
1. Remove a gas-distributing belt.
2. Stop an asterisk and unscrew a bolt. Remove an asterisk.

Installation

Installation is carried out upside-down removals.