Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 3.2. Diesel engines
   - 3.2.1.2. Technical characteristics
      3.2.1.3. Sinkhronizatsionnye of a gazoraspredeleniye label
      3.2.1.4. Compression check
      3.2.1.5. Gas-distributing belt
      3.2.1.6. Natyazhitel of a gas-distributing belt, asterisk
      3.2.1.7. Additional driving belts
      3.2.1.8. Camshaft cover
      3.2.1.9. Camshaft epiploon
      3.2.1.10. Epiploon of an intermediate shaft
      3.2.1.11. Epiploons of a cranked shaft
      3.2.1.12. Head of cylinders
      3.2.1.13. Hydraulic pushers
      3.2.1.14. Flywheel
      3.2.1.15. Engine fastenings
      3.2.1.16. Oil pallet
      3.2.1.17. Oil pump and maslozaborny branch pipe
   + 3.2.2. 5-cylinder engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

3.2.1.5. Gas-distributing belt

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. To remove the top cover of a belt, unscrew screws.
3. Get inserts and disconnect latches.
4. Uncover.
6. Remove driving belts and a pulley of the water pump.
7. Establish the N1 piston in VMT.
8. Remove a pulley of a cranked shaft.
9. Remove the bottom cover of a gas-distributing belt.
10. Weaken a bolt of a natyazhitel and remove a gas-distributing belt.

Check

Examine a belt on existence of pollution by greasing or oil, and also on existence of wear or damages. If necessary replace a belt.

Installation


PERFORMANCE ORDER
1. Weaken a bolt of an asterisk of a camshaft and slightly shift an asterisk from a shaft.
2. Put on a belt asterisks.
3. Put on a belt a pulley of a natyazhitel.
4. Pass a belt under the bottom pulley.
5. Get the blocking probe from an asterisk of the fuel pump.
6. Turn a pulley of a natyazhitel clockwise to combine labels on a pulley and on a nave. Tighten a lock-nut of a natyazhitel.
7. Tighten a bolt of an asterisk of a camshaft.
8. Establish the remained details.