Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1.1.2. Technical characteristics
      3.1.1.3. Sinkhronizatsionnye of a gazoraspredeleniye label
      3.1.1.4. Compression check
      3.1.1.5. Gas-distributing belt
      3.1.1.6. Natyazhitel of a gas-distributing belt, asterisk
      3.1.1.7. Additional driving belts
      3.1.1.8. Camshaft cover
      3.1.1.9. Camshaft epiploon
      3.1.1.10. Epiploon of an intermediate shaft
      3.1.1.11. Epiploons of a cranked shaft
      3.1.1.12. Head of cylinders
      3.1.1.13. Hydraulic pushers
      3.1.1.14. Flywheel
      3.1.1.15. Engine fastenings
      3.1.1.16. Oil pallet
      3.1.1.17. Oil pump and maslozaborny branch pipe
   + 3.1.2. 5-cylinder engines
   + 3.1.3. 6-cylinder engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c
Fiat Albea - ��� ���������� Fiat Albea

3.1.1.8. Camshaft cover

ADR ENGINE

Removal

PERFORMANCE ORDER
1. Remove the top cover of the engine.
2. Remove an air inlet located between the air filter and a casing of a throttle.
3. Disconnect wires from the ignition coil. Disconnect a grounding wire.
4. Braid nuts and uncover a camshaft.
5. Remove laying and a maslootrazhatel from a cover

Installation

PERFORMANCE ORDER
1. Clean surfaces of a cover and a head of cylinders, establish new laying.
2. Establish a maslootrazhatel.
3. Establish a cover on a head and tighten bolts.
4. Establish the remained details.

ALL ENGINES, EXCEPT ADR

Removal
PERFORMANCE ORDER
1. Remove the top cover of a gas-distributing belt.
2. Remove the top part of a back cover of a gas-distributing belt.
3. Braid nuts of a cover of a camshaft.
4. Remove strengthening plates and uncover a camshaft.
5. Remove a maslootrazhatel.
6. Remove laying.
7. Remove the semicircular laying located in a flute of a cover of the forward bearing of a camshaft and get the rubber cap located in a back part of a head of cylinders.

Installation

PERFORMANCE ORDER
1. Clean surfaces of a cover and a head of cylinders.
2. Establish details upside-down.