Audi 100/A6

1990-1997 of release

Repair and car operation

And – the display

B–yellow control lamp of readiness for programming of time of inclusion

C–green control lamp of inclusion of a heater

D–heating / ventilation key

Е–coin acceptor

key of programming of time of the first inclusion

key of programming of time of the second inclusion

key for reading of real time

operative inclusion and heater or fan switching off for supply of fresh air

installation of real time with a countdown

installation of real time with direct counting

Reading of real time

Press and hold a key . Indication is highlighted, while the key is pressed. At a key otpuskaniye it dies away. If, however, before it inclusion time was programmed, it remains on indication still approximately within 2 seconds.

Installation of real time

Press and hold a key .

Keys  (countdown) and  (direct counting) adjust hours on the actual exact time.

Key of control (D) for a heating / ventilation mode

Standard option of control for a summer season:

At the pressed key the device works only as the fan for supply of fresh air, and the heater does not join. A control lamp (C) heater inclusions at work in a mode of the fan does not burn.

Inclusion and switching off, and also programming of time of start-up of the device in a mode of the independent fan are carried out the same as it is described below for a heating mode.

Standard option of control for a winter season:

At not pressed key the device works as a heater.

Inclusion and switching off of an independent heater

Before inclusion execute control of system of heating and ventilation.

Key D establish in a mode of an independent heater.

Inclusion is carried out by key pressing. The heater will earn at once. At its inclusion the control lamp (C) burns.

Switching off is carried out by key pressing. A control lamp (C) thus dies away.

After 60 mines of work in a mode of an independent heater the device is automatically switched off.

Programming of time of inclusion of a heater

Keys   also    it is possible to program two various times of inclusion of a heater within one days.

Press a key    or  . On the display there is an indication of the corresponding key. The control lamp (In), confirming readiness of the programming device for work burns.

The necessary time of inclusion of a heater is set by keys of installation of time with direct and a countdown. With increase in duration of deduction of these keys counting of time is accelerated.

Approximately in 20 seconds after implementation of this control indication of programmed time dies away. However on the display there is number of a setting key    or   , confirming programming.

Key (D) establish in a mode of an independent heater.

Carry out heating and ventilation control.

Cancellation / confirmation of programmed time of inclusion

For cancellation press a key    or   thus will go out key number on the display and a control lamp (In), confirming readiness of the programmed device.

Confirmation of the programmed inclusion is carried out by pressing of keys    or   . The control lamp thus lights up (In).

Standard options of control

Cars with usual system of ventilation and heating

For work in a mode of an independent heater and the fan it is necessary to execute following operations on system control:

For warming up of salon turn a temperature regulator clockwise against the stop.

The air distributor establish in a mode of thawing of glasses or space heating for feet, or between provisions    and   .

The switch of operating modes of the fan establish in situation II. On cars with usual system of heating and ventilation it is impossible to establish this switch in situation 0 as access of fresh air is thus blocked.

Cars with the automatic conditioner

Special control it is not required. For thawing of glasses air moves automatically.