Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
- 1. Maintenance instruction
   1.2. Dashboard Audi A6/A6 Avant, S6/S6 Avant
   1.3. Alarm and control lamps
   + 1.4. Installation of seats
   1.5. Electric window regulators
   1.6. Installation of a steering wheel
   1.7. Ignition lock
   1.8. Switches
   1.9. Lever switches of light
   1.10. Screen wipers and stekloomyvatel
   1.11. Heating and ventilation
   1.12. Conditioner
   1.13. Installation of external mirrors
   1.14. Electric put external mirrors
   1.15. Elevating and movable panel of a roof
   1.16. Folding cover of the refueling hatch
   1.17. Automatic transmission
   1.18. Dynamic program of switching (DPS)
   1.19. Spare or emergency program
   1.20. Provision of a control lever
   1.21. Kick-down device
   1.22. Recommendations about driving
   1.23. Combination of devices
   1.24. Control lamps
   1.25. Symbols of red color (1 degree of priority)
   1.26. Symbols of yellow color (the 2nd degree of priority)
   1.27. Board computer
   1.28. Switches
   1.29. System of maintenance of constant speed
   1.30. System of screen wipers and stekloomyvatel
   1.31. Automatic conditioner
   1.32. Airfinal devices
   1.33. Control panel independent heater
   1.34. Electronic blocking of differential (EDS)
   1.35. Control of level of oil
   1.36. Amplifier of the helmsman of drive / Servotronic, regulator of a road gleam
   1.37. Cooling system
   1.38. Brake liquid
   1.39. Color designations of safety locks
   + 1.40. Replacement of lamps
   1.41. Auxiliary branch
   1.42. Implementation of the starting help
   1.43. Passport data of the car
   1.44. 4-cylinder engine in volume of 1,8 l
   1.45. 4-cylinder engine in volume of 1,9 l
   1.46. 5-cylinder diesel engine
   1.47. Recommended pressure in tires
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

1.29. System of maintenance of constant speed
GENERAL INFORMATION

By means of this system – within the possibilities defined by engine capacity, – it is possible to support any set speed, beginning approximately with 40 km/h. Thanks to it it is not required to hold a foot on an accelerator pedal that is especially convenient at distant trips.
Prevention

The system of maintenance of constant speed cannot use at high intensity of movement and an adverse condition of the carriageway (for example, ice, danger of hydroplaning, gravel emission).

At speed over 40 km/h and the included system be not switched to neutral transfer without выжима coupling pedals! Otherwise probably sharp increase in turns of the engine that in certain circumstances is fraught with its breakage!

For using system serve a cursor And and the button B on the lever switch of turn and a passing beam.

Inclusion

The system joins transfer of a cursor And to the situation EIN.

Programming of speed

At achievement of desirable speed to press and release the button In (FIA). The set speed is observed.

Speed can be increased over the programmed value in pressing of a pedal of an accelerator. After a pedal otpuskaniye the system will adjust speed with return to earlier programmed size. It does not belong to cases with excess of the programmed speed more than on 10 km/h over 5 minutes. In this case anew program speed.

Change of speed

Reduction of speed

It is possible to reduce the established speed in pressing of the button of V.Pri each short-term pressing of the button speed decreases on 1,5 km/h. When keeping button in the pressed situation speed decreases automatically. At an otpuskaniye of the button speed is programmed at present.

At an otpuskaniye of the button of the car moving with a speed less than 40 km/h, there is a dumping of memory of a memory. In this case, after achievement of speed over 40 km/h to program anew speed the button B.

Increase in speed

The established speed can be increased reduction of a cursor And in the situation AUFN without pressing an accelerator pedal.

By each short-term pressing of the button speed increases by 1,5 km/h. When keeping button in the pressed situation speed increases automatically. At an otpuskaniye speed is programmed at present.

Temporary shutdown of system

Temporary shutdown of system occurs by pressing of a pedal of a brake or coupling or at transfer of a cursor And to the situation AUS (without fixing). The speed programmed to this moment remains in memory.

For reproduction (AUFN) of earlier programmed speed transfer a cursor And to extreme left situation, having released a brake or coupling pedal.

If at temporary shutdown speed not to program, new speed is established by the switch A in the following order:

On cars with the petrol engine quickly to bring into extreme left situation the switch A, then again to shift it to the left and to hold before achievement of the necessary speed.

On cars with the diesel engine it is enough to wring out the switch A to the left against the stop and to hold it before achievement of the necessary speed. At an otpuskaniye of the switch there is a storing of speed.

Prevention

Reproduce the programmed speed only if it is not too high for the actual traffic conditions.

System blackout

The blackout of system is carried out by switch A shift against the stop to the right (the fixed situation AUS) or – at the motionless car – ignition switching off.