Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
- 1. Maintenance instruction
   1.2. Dashboard Audi A6/A6 Avant, S6/S6 Avant
   1.3. Alarm and control lamps
   + 1.4. Installation of seats
   1.5. Electric window regulators
   1.6. Installation of a steering wheel
   1.7. Ignition lock
   1.8. Switches
   1.9. Lever switches of light
   1.10. Screen wipers and stekloomyvatel
   1.11. Heating and ventilation
   1.12. Conditioner
   1.13. Installation of external mirrors
   1.14. Electric put external mirrors
   1.15. Elevating and movable panel of a roof
   1.16. Folding cover of the refueling hatch
   1.17. Automatic transmission
   1.18. Dynamic program of switching (DPS)
   1.19. Spare or emergency program
   1.20. Provision of a control lever
   1.21. Kick-down device
   1.22. Recommendations about driving
   1.23. Combination of devices
   1.24. Control lamps
   1.25. Symbols of red color (1 degree of priority)
   1.26. Symbols of yellow color (the 2nd degree of priority)
   1.27. Board computer
   1.28. Switches
   1.29. System of maintenance of constant speed
   1.30. System of screen wipers and stekloomyvatel
   1.31. Automatic conditioner
   1.32. Airfinal devices
   1.33. Control panel independent heater
   1.34. Electronic blocking of differential (EDS)
   1.35. Control of level of oil
   1.36. Amplifier of the helmsman of drive / Servotronic, regulator of a road gleam
   1.37. Cooling system
   1.38. Brake liquid
   1.39. Color designations of safety locks
   + 1.40. Replacement of lamps
   1.41. Auxiliary branch
   1.42. Implementation of the starting help
   1.43. Passport data of the car
   1.44. 4-cylinder engine in volume of 1,8 l
   1.45. 4-cylinder engine in volume of 1,9 l
   1.46. 5-cylinder diesel engine
   1.47. Recommended pressure in tires
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c



1.31. Automatic conditioner

GENERAL INFORMATION

The conditioner automatically supports a uniform microclimate in all space of salon. For this purpose the temperature of air arriving on stitched channels, and also its mass expense (amount of air) and distribution of air streams automatically changes. In need of this automatic process it is possible to introduce amendments manually.

On an illustration governing bodies by the conditioner, mounted on the average console are shown. The left display serves for indication of temperature and programmed automatic, right – for indication of semi-automatic functions.

Recommended all-weather standard control:

After inclusion of ignition to establish temperature 22 ° With (71 ° to F) and to press a key  .

Such control provides the fastest creation in salon of a comfortable microclimate.

Therefore to recede from it there is a sense only if it is dictated by own health.

Governing bodies

automatic equipment (regular mode)

The temperature, quantity and distribution of air are regulated automatically, by criterion of the fastest achievement and the subsequent maintenance of the necessary temperature in salon. Automatic response to fluctuations of external air is thus provided.

thawing

As fast as possible thaws or the windscreen is released from a zapotevaniye. The temperature is regulated. The maximum supply of air is carried out through cracks 1 and 2.

inclusion and air cooler switching off

For economy of fuel it is possible to switch off the refrigerating unit (compressor). However at the disconnected compressor regulation possibilities with preservation of necessary comfort are limited. If in salon becomes too hot, it is possible or to turn on again the compressor in pressing of the corresponding button, or to press AUTO for entry into an automatic mode.

temperature choice

The temperature in salon can be set in limits from 18 ° With (64 ° F) to 29 ° With (84 ° F). At regulator installation in one of the extreme provisions "LO" and "HI", regulations of temperature do not occur. The system constantly works in a mode maximum hlado-or heatproductivity.

Indication of temperature can be switched from Celsius scale to the Fahrenheit scale and back in the following order:

Press and hold a key . Then press a plusovy key of programming of temperature.

correction of frequency of rotation of the fan

These keys the frequency of rotation of the fan set by automatic equipment (amount of air) raises or goes down. At a contact of one of them on the right display there is man inscription. The actual frequency of rotation is displayed by segment indication near a fan symbol.

By pressing of a minus key in fan operating time at the most low-turnaround step the system is switched off.

For repeated turning on of the conditioner it is enough to press any of the following keys:     one of keys of programming of temperature or plusovy key of the fan. To switch off the conditioner a fan key as a rule it is not required.

retsirkulyatsionny mode

In a retsirkulyatsionny mode access of air is from the outside blocked, and its volume is distributed in salon around. Thereby hit in the car of the air polluted by exhaust gases is prevented. Movement with the conditioner in this mode should not be too long-term.

At a zapotevaniye of glasses at once switch off a retsirkulyatsiya mode in repeated pressing of the button of its inclusion or set a program mode обдува glasses.


Prevention

In need of short-term shutdown of the compressor of the conditioner, for example, owing to excessive loading of the engine, again press a key of a retsirkulyatsiya of air.


Air distributor keys

Keys  ,     also    it is possible to change the programmed mode of the air distributor.

Probably both separate, and the combined manipulation these keys. By pressing of any of them on the right display there is "man" inscription.

supply of air to glasses

Unlike the w/mode all consumption of air is realized by its giving on channels 1 and 2.

supply of air through peripheral lattices

All consumption of air is realized with giving through lattices of 3 and 4 dashboards and on a body floor eminence in a back part of salon.

supply of air in space for feet

All consumption of air is realized via stitched channels 5 and devices for обдува under forward seats. At desire to return to an automatic mode of airdistribution the corresponding functions are switched off separately or key pressing  .