Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
- 1. Maintenance instruction
   1.2. Dashboard Audi A6/A6 Avant, S6/S6 Avant
   1.3. Alarm and control lamps
   + 1.4. Installation of seats
   1.5. Electric window regulators
   1.6. Installation of a steering wheel
   1.7. Ignition lock
   1.8. Switches
   1.9. Lever switches of light
   1.10. Screen wipers and stekloomyvatel
   1.11. Heating and ventilation
   1.12. Conditioner
   1.13. Installation of external mirrors
   1.14. Electric put external mirrors
   1.15. Elevating and movable panel of a roof
   1.16. Folding cover of the refueling hatch
   1.17. Automatic transmission
   1.18. Dynamic program of switching (DPS)
   1.19. Spare or emergency program
   1.20. Provision of a control lever
   1.21. Kick-down device
   1.22. Recommendations about driving
   1.23. Combination of devices
   1.24. Control lamps
   1.25. Symbols of red color (1 degree of priority)
   1.26. Symbols of yellow color (the 2nd degree of priority)
   1.27. Board computer
   1.28. Switches
   1.29. System of maintenance of constant speed
   1.30. System of screen wipers and stekloomyvatel
   1.31. Automatic conditioner
   1.32. Airfinal devices
   1.33. Control panel independent heater
   1.34. Electronic blocking of differential (EDS)
   1.35. Control of level of oil
   1.36. Amplifier of the helmsman of drive / Servotronic, regulator of a road gleam
   1.37. Cooling system
   1.38. Brake liquid
   1.39. Color designations of safety locks
   + 1.40. Replacement of lamps
   1.41. Auxiliary branch
   1.42. Implementation of the starting help
   1.43. Passport data of the car
   1.44. 4-cylinder engine in volume of 1,8 l
   1.45. 4-cylinder engine in volume of 1,9 l
   1.46. 5-cylinder diesel engine
   1.47. Recommended pressure in tires
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

1.28. Switches

GENERAL INFORMATION

 

1–switch of electroheating of a seat of the driver

Switches are executed in the form of corrugated handles.

At the included ignition it is possible to use electroheating of pillows, backs of lobbies and extreme back seats, and also a steering wheel. The corrugated handle (1) it is possible to include and бесступенчато to regulate heating of a seat of the driver, and the handle (8) – heating of a seat of the forward passenger. At inclusion of heating of a seat there is an automatic inclusion of heating of a steering wheel. The temperature is set in advance and is not regulated by the handle (1).

 

Heating of back seats joins and regulated by independently corrugated handles mounted in a back part of the average console: and – at the left, b – on the right.

Electroheating of back seats works only when finding passengers on it.

For heating inclusion the corresponding corrugated handle is deduced from situation 0 and turns with installation in one of six possible temperature ranges. At the same time with a heating system illumination of a digital marking of the corresponding corrugated handle joins also.

2–switch of fog lights

Fog lights burn at inclusion of lay fires, a passing or driving beam.

At their inclusion the control lamp which has been built in in the switch burns. At the included back fog light independent inclusion of forward fog lights is impossible.

Observe existing instructions for use antifog lighting.

3–switch of a back fog light

The back fog light burns only at the included passing or driving beam, and on cars with forward fog lights – also at included lay fires. At inclusion of a back fog light also lobbies automatically join. Thus in both switches control lamps light up.

Observe existing instructions for use antifog lighting.

On cars with the security alarm system in the same switch the light-emitting diode is in addition mounted.

4–switch of electroheating of back glass

Electroheating works only at the included ignition. While it is included, in its switch the control lamp burns.

Electroheating of back glass is switched off approximately in 10 minutes independently.

As soon as visibility through zadney glass will be restored, its heating needs to be switched off. Having reduced an electric power expense, you will reduce also fuel consumption.


Prevention

If back glass is equipped with a radio antenna, it are three top links of the conductor which naturally do not heat up.


Electroheating of mirrors

Reflective surfaces of mirrors are warmed at the included electroheating of back glass.

5–switch of the alarm light system

At turning on of the alarm light system synchronously with it the red control lamp in its switch blinks.

Besides illumination of both arrows on the dashboard, indexes of turn confirming work blinks. The alarm system works and at the switched-off ignition.


Prevention

Observe instructions for use the alarm light system.


6–a regulator of the fuel filter (diesel engine) or level of cooling liquid

7–regulator of a tilt angle of headlights

Electric regulator of a tilt angle of headlights during movement of the car it is possible бесступенчато to change the provision of their optical axes according to the actual loading of the car. Thanks to it extent of dazzle of drivers of counter transport will not exceed inevitable level. At the same time the correct installation of headlights creates the most favorable visibility conditions of the road for the driver.

For increase in a tilt angle of light cones turn from a starting position (0) down the regulator handle. Noted provisions of a regulator approximately correspond to the following condition of loading of the car:

0–in the car the driver and the forward passenger, a luggage carrier is empty

I–all places are occupied, the luggage carrier is empty

II – all places are occupied, the luggage carrier is loaded

III – took a place of the driver, the luggage carrier is loaded.

8–device of regulation of a proskalzyvaniye of driving wheels (ASR)

Reducing engine capacity, the ASR device interferes with a probuksovyvaniye of driving wheels at a troganiye from a place or acceleration of front-wheel cars. The device works together with ABS (anti-blocking system of brakes). At malfunction of ABS ASR does not operate also. The ASR device turns on automatically at engine start-up. In need of it it is possible to include and disconnect in switch pressing. At the disconnected device its control lamp burns.

Usually the ASR device should be always switched on. Only in certain exceptional cases, in need of a proskalzyvaniye, it is possible to disconnect the device, namely:

  – at movement with the established emergency spare wheel;
  – at movement with antisliding chains;
  – at movement on deep snow or friable soil;
  – in attempt to leave in a swing after jamming;
  – at arrival on liftings with the extremely various extent of coupling of driving wheels (for example, under the left wheel – ice, under right – dry asphalt).

After that again to turn on the device.


Prevention

Condition of continuous work of ASR is installation of the same tires on all four wheels of the car. Unequal tires can lead to undesirable decrease in engine capacity.


Switch light / switch of the index of turns and passing beam

And – light switch

0–lighting is switched off

1–lay fires are included

2–the passing or driving beam is included

In – the lever switch of the index of turns and a passing beam

Headlights burn only at the included ignition.


Prevention

After key extraction from the ignition lock at not switched off light and an open door of the driver the warning sound signal is distributed.


Indexes of turns work only at the included ignition.

For inclusion of the right indexes of turns – the lever up.

For inclusion of the left indexes of turns – the lever down.

At the included indexes of turn the control lamp synchronously blinks.

After completion of turn indexes are switched off automatically.

Signal giving about lane change

The lever is wrung out up or down to a point of resistance and keeps in this situation – the control lamp synchronously should blink.

Inclusion of near and far light

For inclusion of a passing beam – the lever in average situation.

For switching on a driving beam – the lever to wring out forward.

Faltering light signal

Delay the lever to a steering wheel to a resistance point – the control lamp of a driving beam lights up.

Inclusion of lay fires

Lay fires burn only at the switched-off ignition.

For inclusion of lay fires on the right – the lever up.

For inclusion of lay fires at the left – the lever down.