Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
- 9. Transmission
   - 9.1.2. Technical characteristics
      9.1.3. Pumping of hydraulic system of a drive of switching off of coupling
      9.1.4. Coupling adjustment
      9.1.5. Coupling pedal
      9.1.6. Main cylinder of a drive of switching off of coupling
      9.1.7. Working cylinder of a drive of switching off of coupling
      9.1.8. Disk of coupling and casing
      9.1.9. Vyzhimna bearing and lever
      9.1.10. Malfunctions of coupling
   + 9.2. Mekhnichesky transmission
   + 9.3. Automatic transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

9.1.6. Main cylinder of a drive of switching off of coupling

GENERAL INFORMATION

Elements of the main cylinder of a drive of switching off of coupling
1. Tank
2. Hose
3. Plug
4. Adapter
5. Cap
6. Main cylinder
7. Bolt
8. Lock-nut
9. Fork
10. Pin
11. Lock ring
12. Tube
13. Plug
14. Washer
15. Fastening
16. Plug
17. Washer
18. Hose
19. Working cylinder
20. Pumping valve
21. Cap
22. Connection nut

The main cylinder is located on a fixing arm of pedals of a brake and coupling.

Removal

PERFORMANCE ORDER
1. Remove the furnish panel.
2. Press the hydraulic hose going from a tank to the cylinder.
3. Disconnect a hydraulic hose and a tube from the cylinder.
4. Disconnect a cylinder pusher from a coupling pedal.
5. Turn off fixing bolts and remove the cylinder.

Repair

PERFORMANCE ORDER
1. Remove a cover and a pusher.
2. Remove a lock ring from the basis of the cylinder and remove a washer, the piston and a spring.
3. Clear all elements and examine them on existence of wear or damages. Replace the cylinder if it is necessary.
4. Grease new consolidations in hydraulic liquid and establish them on the piston.
5. Insert a spring and the piston into the cylinder.
6. Establish a washer and a lock ring.
7. Establish a pusher and a cover. Tighten up a pusher fork so that the distance from the opening center on a fork to the main cylinder was 109,5±0,5 mm.

Installation

Installation is carried out upside-down removals.