Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   + 6.1.2. Technical characteristics
   - 6.2. Multipoint system of injection of fuel
      6.2.2. Technical characteristics
      6.2.3. Air filter
      6.2.4. Accelerator rope
      6.2.5. Elements of system of injection of Motronic/Jetronic fuel
      6.2.6. Elements of system of injection of Digifant fuel
      6.2.7. Fuel filter
      6.2.8. Fuel pump and fuel level sensor
      6.2.9. Fuel tank
      6.2.10. Pressure release from system of injection of fuel
      6.2.11. Inlet collector
      6.2.12. Check of system of injection of fuel
      6.2.13. Unleaded gasoline
   + 6.3. System of injection of MPI/MPFI (6-cylinder engines)
   + 6.4. Power supply system of diesel engines
   6.5. Device of service of heating
   6.6. Diagnostics of malfunctions of system of heating
   6.7. Conditioner: not only "pluses", but also "minuses"
   6.8. Rules of service of the conditioner
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

6.2.9. Fuel tank

GENERAL INFORMATION

Elements of a fuel tank on models with the ADR engine coding

1. Tube of supply of fuel
2. A hose going to the coal filter
3. Return pipeline
4. Perepuskny tube
5. Tube of a jellied mouth
6. Insert

7. Clip
8. Fuel tank
9. Bolt of connection of a banjo
10. Fixing ring
11. Fuel level sensor
12. Fuel pump

Elements of a fuel tank on models with the AAD engine coding

1. Bolt of connection of a banjo
2. Copper washers
3. Fixing ring
4. Fuel level sensor
5. Sealing ring
6. Clip
7. Pressure chamber
8. Fuel pump
9. Return pipeline
10. Fuel tank
11. Dempfernye of laying

12. Shling of a jellied mouth
13. Clip
14. Insert
15. Tube of a jellied mouth
16. Perepuskny tube
17. Return pipeline
18. Protective hose
19. Ventilation valve
20. Ventilating tube
21. Tube of supply of fuel

Removal

PERFORMANCE ORDER

1. Disconnect the socket of connection and hoses from the pump / fuel level sensor.

2. Establish a jack under a fuel tank.

3. Disconnect a hose of a jellied mouth from a fuel tank.

4. Turn off nuts of fixing strips of a fuel tank and remove a fuel tank.

Installation

Installation is carried out upside-down removals.