Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   + 6.1.2. Technical characteristics
   - 6.2. Multipoint system of injection of fuel
      6.2.2. Technical characteristics
      6.2.3. Air filter
      6.2.4. Accelerator rope
      6.2.5. Elements of system of injection of Motronic/Jetronic fuel
      6.2.6. Elements of system of injection of Digifant fuel
      6.2.7. Fuel filter
      6.2.8. Fuel pump and fuel level sensor
      6.2.9. Fuel tank
      6.2.10. Pressure release from system of injection of fuel
      6.2.11. Inlet collector
      6.2.12. Check of system of injection of fuel
      6.2.13. Unleaded gasoline
   + 6.3. System of injection of MPI/MPFI (6-cylinder engines)
   + 6.4. Power supply system of diesel engines
   6.5. Device of service of heating
   6.6. Diagnostics of malfunctions of system of heating
   6.7. Conditioner: not only "pluses", but also "minuses"
   6.8. Rules of service of the conditioner
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c


6.2.8. Fuel pump and fuel level sensor

Removal

PERFORMANCE ORDER
1. The fuel pump and the fuel level sensor are established in a fuel tank.
2. Remove the panel from above a fuel tank.
3. Disconnect the socket of connection of the pump / sensor.
4. Disconnect fuel and ventilating hoses, having marked them.
5. Turn off a fixing ring and get the pump / sensor.
6. Disconnect hoses in the pump and the connection socket.
7. Turn the pump counter-clockwise approximately on 15 mm and remove it from fastening.

Installation

Installation is carried out upside-down removals.