Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   - 6.1.2. Technical characteristics
      6.1.3. Air filter and branch pipes of a fence of air
      6.1.4. A regulator of temperature of arriving air
      6.1.5. Accelerator rope
      6.1.6. Elements of system of injection of fuel
      6.1.7. Fuel filter
      6.1.8. Fuel pump and fuel level sensor
      6.1.9. Fuel tank
      6.1.10. Pressure release from system of injection of fuel
      6.1.11. Inlet collector
      6.1.12. Check of system of injection of fuel
      6.1.13. Unleaded gasoline
   + 6.2. Multipoint system of injection of fuel
   + 6.3. System of injection of MPI/MPFI (6-cylinder engines)
   + 6.4. Power supply system of diesel engines
   6.5. Device of service of heating
   6.6. Diagnostics of malfunctions of system of heating
   6.7. Conditioner: not only "pluses", but also "minuses"
   6.8. Rules of service of the conditioner
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

6.1.2. Technical characteristics

GENERAL INFORMATION

System type
Models with the AAE engine coding	Bosch Mono-Motronic
Power supply system
Type of the fuel pump	The electric pump, is established in a fuel tank
Pump capacity	1400 ^cm3/minutes (working tension of 12,5 Volts)
Pressure of fuel	0,8-1,2 Bar
Speed of idling	750-1000 rpm (are not regulated)
Maximum speed of operation of the engine	6400 rpm (electronic adjustment)
Resistance of an injector	1,2-1,6 Ohm at 15 ° With
The recommended type of fuel
Minimum octane number of gasoline:
– engines in capacity of 74 kW	91 RON

Moments of an inhaling, N of m.

Fastening of a tube of the WITH sensor to an inlet collector	20
Fixing nut of a damper	10
Bolt of connection of a banjo of the fuel pump	20
Nuts of plugs of wires on the fuel pump:
– М5	4
– М6	7
Fixing screw of a casing of the injector / sensor of air temperature	5
Fixing screws of a heater of an inlet collector	10
Fixing bolts of an inlet collector	25
Fixing screw of an air branch pipe	10
Fastening of the case of a butterfly valve to an inlet collector	13
Fixing screws of the case of a butterfly valve	10
Fastening of the top section of the case of a butterfly valve	6
Fixing screws of the module of positioning of a butterfly valve	6
Fastening of a branch pipe of warm air to a final collector	20