Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 3.2. Diesel engines
   + Technical characteristics
   - 3.2.2. 5-cylinder engines Technical characteristics Sinkhronizatsionnye of a gazoraspredeleniye label Compression check Gas-distributing belt Driving belt of the fuel pump Natyazhitel of a gas-distributing belt and asterisk Additional driving belt Camshaft cover Camshaft epiploons Epiploons of a cranked shaft Head of cylinders Hydraulic pushers Flywheel Engine fastenings Oil pallet Oil pump and maslozaborny branch pipe
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

ff85f19c Oil pump and maslozaborny branch pipe


1. Remove a gas-distributing belt and an asterisk of a cranked shaft.
2. Remove the oil pallet.
3. Remove the ventilating channel in a back part of the block.
4. Remove a lock ring of the filter of a maslozaborny branch pipe.
5. Remove the filter (AAT).
6. Unscrew branch pipe bolts.
7. Unscrew bolts of an arm of a branch pipe.
8. Remove a branch pipe.
9. Get a sealing ring.
10. Unscrew bolts and remove the oil pump.
11. Remove pump laying.


1. Uncover the pump.
2. Unscrew a cap of the reduktsionny valve.
3. Get a washer, a spring.
4. Get the piston (AAT).
5. Examine all details of the pump and the valve on existence of wear and damages.
6. If necessary replace an epiploon of a cranked shaft.
7. Collect the pump and the reduktsionny valve. Tighten a cap of the reduktsionny valve (AAT).


Installation is made in sequence, return to removal.