Repair and operation of the car of Audi 100/A6 - 3.1.2.15. Oil pallet//Audi of 100/A6 1990-1997 / t3r.ru

Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1.1.2. Technical characteristics
   - 3.1.2. 5-cylinder engines
      3.1.2.2. Technical characteristics
      3.1.2.3. Sinkhronizatsionnye of a gazoraspredeleniye label
      3.1.2.4. Compression check
      3.1.2.5. Gas-distributing belt
      3.1.2.6. Natyazhitel of a gas-distributing belt, asterisk
      3.1.2.7. Additional driving belt
      3.1.2.8. Camshaft cover
      3.1.2.9. Camshaft epiploon
      3.1.2.10. Epiploons of a cranked shaft
      3.1.2.11. Head of cylinders
      3.1.2.12. Hydraulic pushers
      3.1.2.13. Flywheel
      3.1.2.14. Engine fastenings
      3.1.2.15. Oil pallet
      3.1.2.16. Oil pump and maslozaborny branch pipe
   + 3.1.3. 6-cylinder engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c ãã ïîêåðîê êîä

3.1.2.15. Oil pallet

GENERAL INFORMATION

Oil pallet

1. Oil щуп
2. Sealing ring
3. Sensor of pressure of oil 0,3 bar
4. Sensor of pressure of oil 1,8 bar
5. Maslozaborny branch pipe
6. Dividing partition
7. Pallet
8. Bolt
9. Cap of a drain opening
10. Bolt
11. Flywheel cover
12. Washer
13. Rubber cover
14. Lock spring
15. Bolt
16. Emphasis
17. Laying
18. Bolt
19. Pallet laying
20. Adapter
21. Valve
22. Oil filter
23. Cover of a jellied mouth

Removal

PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Get oil щуп and remove the bottom guard of the engine.
3. Merge oil.
4. Remove a forward cover of a transmission.
5. Turn a cranked shaft so that to get access to back bolts of the pallet (arrow).
6. Fix the engine on the lift.
7. Braid the bottom nuts of a support of the engine.
8. Establish a jack under a cross-piece of a forward suspension bracket, unscrew bolts and slightly lower a cross-piece.
9. Unscrew pallet bolts.
10. Remove the pallet.

Installation

PERFORMANCE ORDER
1. Clean surfaces of the pallet and the block of cylinders and establish new laying.
2. Installation is carried out upside-down removals.