Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   - 6.1.2. Technical characteristics
      6.1.3. Air filter and branch pipes of a fence of air
      6.1.4. A regulator of temperature of arriving air
      6.1.5. Accelerator rope
      6.1.6. Elements of system of injection of fuel
      6.1.7. Fuel filter
      6.1.8. Fuel pump and fuel level sensor
      6.1.9. Fuel tank
      6.1.10. Pressure release from system of injection of fuel
      6.1.11. Inlet collector
      6.1.12. Check of system of injection of fuel
      6.1.13. Unleaded gasoline
   + 6.2. Multipoint system of injection of fuel
   + 6.3. System of injection of MPI/MPFI (6-cylinder engines)
   + 6.4. Power supply system of diesel engines
   6.5. Device of service of heating
   6.6. Diagnostics of malfunctions of system of heating
   6.7. Conditioner: not only "pluses", but also "minuses"
   6.8. Rules of service of the conditioner
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

6.1.8. Fuel pump and fuel level sensor

GENERAL INFORMATION

Elements of a fuel tank

1. Tube of supply of fuel
2. Ventilating hose
3. The ventilating hose going to the coal filter
4. Ventilating valve
5. Fastening
6. Return pipeline
7. Jellied
8. Perepuskny tube
9. Tube of a jellied mouth
10. Insert
11. Clip

12. Hose
13. A tube of the return pipeline in a fuel tank
14. Dempflernye of laying
15. Bolt of connection of a banjo
16. Sealing washers
17. Fixing ring
18. Fuel level sensor
19. Sealing ring
20. Fuel pump
21. Fuel tank

Removal

PERFORMANCE ORDER

1. The fuel pump and the fuel level sensor are established in a fuel tank.

2. Remove the panel from above a fuel tank.

3. Disconnect the socket of connection of the pump / sensor.

4. Disconnect fuel and ventilating hoses, having marked them.

5. Turn off a fixing ring and get the pump / sensor.

6. Disconnect hoses in the pump and the connection socket.

7. Turn the pump counter-clockwise approximately on 15 mm and remove it from fastening.

Installation

Installation is carried out upside-down removals.