Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1.1.2. Technical characteristics
   + 3.1.2. 5-cylinder engines
   - 3.1.3. 6-cylinder engines
      3.1.3.2. Gear belt
      3.1.3.3. Head of cylinders
      3.1.3.4. Valves
      3.1.3.5. Replacement of maslosjemny caps of valves
      3.1.3.6. Check of directing valves
      3.1.3.7. Fair processing of a landing facet of the saddle / valve
      3.1.3.8. Grinding in of saddles of valves
      3.1.3.9. Compression check
      3.1.3.10. Poliklinova belt
      3.1.3.11. Greasing system
      3.1.3.12. Oil pump
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

3.1.3.12. Oil pump

Removal

PERFORMANCE ORDER

1. The oil pump is in front of the block of cylinders and is brought from a cranked shaft.

2. Remove a poliklinovy belt.

3. Remove a gear belt.

Prevention

After that a cranked shaft and a camshaft any more do not turn.

4. Remove the bottom and top parts of the oil pallet.

5. Unscrew a tension roller of a gear belt.

6. Unscrew directing roller of a gear belt.

7. Turn out a carving stopper on the right over a tension roller.

8. Unscrew the oil pump.

Installation

PERFORMANCE ORDER

1. Replace a sealing ring of the oil pump. A sealing edge and an external surface of a sealing ring slightly oil. Press a sealing ring aflush.

2. Replace the oil pump only assembled.

3. Sealing laying of the oil pump replace, the pump put and tighten bolts the moment of 10 Nanometers. At installation of the oil pump watch a pulley of a cranked shaft.

4. Wrap the cleared carving stopper over a tension roller the moment of 45 Nanometers.

5. Tighten a tension roller of a gear belt the moment of 45 Nanometers.

6. Tighten directing roller of a gear belt the moment of 20 Nanometers.

7. Tighten the top and bottom parts of the oil pallet the moment of 10 Nanometers.

8. Establish a gear belt.

9. Establish poliklinovy a belt.

10. Fill in oil, insert the index of level of oil.

11. Execute a control trip and check the oil pallet on tightness.