Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Systems of start, ignition
   + 8.1.1. Introduction
   - 8.2. Ignition system (petrol engines)
      + 8.2.1.1. Principle of work of PMS
      8.2.2. Technical characteristics
      8.2.3. Check of system of ignition
      8.2.4. Ignition coil
      8.2.5. Ignition distributor
      8.2.6. Corner of an advancing of ignition
      8.2.7. Sensors of system of ignition
      8.2.8. Begunok of the ignition distributor
      8.2.9. Ignition system (6-cylinder engines 2,6 and 2,8 of l)
      8.2.10. Diagnostics of malfunctions of system of injection of gasoline
      8.2.11. That it is necessary to know to the owner of the car with the injector engine
      8.2.12. Turbo doctor
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of production of exhaust gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

8.2.7. Sensors of system of ignition

SENSOR OF DETONATION COMBUSTION OF FUEL

Removal

PERFORMANCE ORDER

1. Remove the filter from below the engine.
2. Disconnect the socket of connection of the sensor.
	3. Turn off a fixing bolt (shooter) and remove the sensor.

Installation

Installation is carried out upside-down removals.

THE HALL SENSOR (ADR ENGINES WITH MOTRONIC 3.2 SYSTEM

PERFORMANCE ORDER

1. Remove an external casing of a gas-distributing belt.
	2. Disconnect the socket of connection of the sensor.
3. Turn off fixing bolts and remove the sensor.

Installation

Installation is carried out upside-down removals.

THE HALL SENSOR (EXCEPT ADR ENGINES)

On these models the sensor of the Hall is a part of the distributor of ignition and is not subject to replacement.