Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Systems of start, ignition
   + 8.1.1. Introduction
   - 8.2. Ignition system (petrol engines)
      + 8.2.1.1. Principle of work of PMS
      8.2.2. Technical characteristics
      8.2.3. Check of system of ignition
      8.2.4. Ignition coil
      8.2.5. Ignition distributor
      8.2.6. Corner of an advancing of ignition
      8.2.7. Sensors of system of ignition
      8.2.8. Begunok of the ignition distributor
      8.2.9. Ignition system (6-cylinder engines 2,6 and 2,8 of l)
      8.2.10. Diagnostics of malfunctions of system of injection of gasoline
      8.2.11. That it is necessary to know to the owner of the car with the injector engine
      8.2.12. Turbo doctor
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of production of exhaust gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

8.2.5. Ignition distributor

Removal

AAE, ABK, AAD AND AAR ENGINES

PERFORMANCE ORDER
1. Establish the N1 cylinder piston in situation VMT.
2. Disconnect wires and the socket of connection of the sensor of the Hall from the ignition distributor.
3. Turn off fixing screws, release clips and uncover the distributor. Check, that the begunok was combined with a mark of the N1 cylinder in the case.
4. Mark the provision of installation of the distributor on the block of cylinders.
5. Turn off a fixing bolt and remove the distributor. Remove a sealing ring.

ENGINE EXPERT

PERFORMANCE ORDER

1. Establish the N1 cylinder piston in situation VMT.

2. Disconnect wires and the socket of connection of the sensor of the Hall from the ignition distributor.
3. Remove the filter, turn off fixing screws and uncover the distributor. Check, that the begunok was combined with a mark of the N1 cylinder in the case.
4. Mark the provision of installation of the distributor on the block of cylinders.
5. Turn off fixing screws and remove the distributor. Remove a sealing ring.

Check

PERFORMANCE ORDER
1. Examine a sealing ring and replace it if it is necessary.
2. Examine a leading gear wheel and replace the distributor if it is worn-out.

Installation

PERFORMANCE ORDER
1. Check, that the piston of the N1 cylinder was in the family way VMT.

AAE, ABK, AAD AND AAR ENGINES

PERFORMANCE ORDER
2. Check, that the uvula on the leader to a shaft stood parallel to an axis of a cranked shaft.
3. Establish a new sealing ring and establish the distributor into place. Check, that the begunok was combined with a mark of the N1 cylinder in the case, and also that marks in the case of the distributor and the block of cylinders coincided.

ENGINE EXPERT

PERFORMANCE ORDER
4. Establish a new sealing ring and establish the distributor into place. Check, that coincided made before a mark, and tighten fixing screws. Further installation is carried out upside-down removals.