Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Systems of start, ignition
   - 8.1.1. Introduction
      8.1.2. Technical characteristics
      - 8.1.3. Accumulator
         8.1.3.2. Removal and installation
      + 8.1.4. Generator / system of additional charge of the accumulator
      8.1.5. Replacement of the holder of brushes and regulator of tension of the generator
      8.1.6. Check of system of start of the engine
      8.1.7. Starter
      8.1.8. Inlet gas pipeline
      8.1.9. Cable gas/lever of a butterfly valve (DB)
      8.1.10. Cable of management of gas (DB)
      8.1.11. Contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. Fuel thermostat
      8.1.14. Hydrovalve case
      8.1.15. Cable gas/lever of a butterfly valve (DD)
      8.1.16. Cable of management of gas (DD)
   + 8.2. Ignition system (petrol engines)
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of production of exhaust gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

8.1.3.2. Removal and installation

GENERAL INFORMATION

The accumulator is located on the left side of an impellent compartment or under back sitting.

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug, and then the plusovy plug of the accumulator.

2. Turn off a bolt and remove a fixing clip of the accumulator.

3. Remove the accumulator from the car.

Installation

Installation is carried out upside-down removals.