Audi 100/A6
1990-1997 of release
Repair and car operation
Audi 100/A6
+
1. Maintenance instruction
+
2. Maintenance
+
3. Engines
+
3.2. Diesel engines
+
3.3. Removal and partition of engines
+
4. Cooling system
+
5. Heating and ventilation
+
6. Fuel system
+
7. Exhaust system
-
8. Systems of start, ignition
-
8.1.1. Introduction
8.1.2. Technical characteristics
+
8.1.3. Accumulator
+
8.1.4. Generator / system of additional charge of the accumulator
8.1.5. Replacement of the holder of brushes and regulator of tension of the generator
8.1.6. Check of system of start of the engine
8.1.7. Starter
8.1.8. Inlet gas pipeline
8.1.9. Cable gas/lever of a butterfly valve (DB)
8.1.10. Cable of management of gas (DB)
8.1.11. Contour of fuel of the diesel engine
8.1.12. Prestarting heating of diesel fuel
8.1.13. Fuel thermostat
8.1.14. Hydrovalve case
8.1.15. Cable gas/lever of a butterfly valve (DD)
8.1.16. Cable of management of gas (DD)
+
8.2. Ignition system (petrol engines)
+
8.3. System of prestarting heating (diesel engines)
+
8.4. System of production of exhaust gases
+
9. Transmission
+
10. Brake system
+
11. Suspension brackets, steering
+
12. Body
+
13. Electric equipment
+
14. Good advice
8.1.7. Starter
Removal
PERFORMANCE ORDER
1.
Remove a protective guard from below the engine.
2.
Disconnect a wire of the involving relay A and a food wire In from a starter.
3.
Turn off a fixing bolt and nuts and remove a fixing arm of a starter.
4.
Turn off fixing bolts and remove a starter.
Installation
Installation is carried out upside-down removals.
Check and repair
For check and repair of a starter it is necessary to address to experts.
