Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
- 2. Maintenance
   + 2.1.2. Regular maintenance
   - 2.2. Models with diesel engines
      2.2.2. Regular maintenance
      2.2.3. Each 15 000 km of run
      2.2.4. Replacement of engine oil and filter
      2.2.5. Check of brake overlays of forward brakes
      2.2.6. Check of drain channels before a windshield
      2.2.7. Liquid plums from the fuel filter
      2.2.8. Dumping of indications of the sensor of maintenance
      2.2.9. Each 12 months
      2.2.10. Check of stekloomyvatel
      2.2.11. Check of adjustment of headlights of head light
      2.2.12. Greasing of loops and locks
      2.2.13. Check of level of electrolit in the accumulator
      2.2.14. Check of the module of memory of EBU
      2.2.15. Check on existence of leaks
      2.2.16. Verification of the content of antifreeze
      2.2.17. Check and replacement of maple driving belts
      2.2.18. Check of brake system
      2.2.19. Check of system of production of the fulfilled gases
      2.2.20. Check of elements of a steering, suspension bracket and semi-axes
      2.2.21. Check of a gas-distributing belt (the 4-cylinder engine)
      2.2.22. Car check in road conditions
      2.2.23. Each 30 000 km of run
      2.2.24. Check and greasing of the mechanism of the top hatch
      2.2.25. Check and replacement of a multiband driving belt
      2.2.26. Check of a gas-distributing belt (the 5-cylinder engine)
      2.2.27. Check of a driving belt of the injecting pump (the engine of 2,5 l)
      2.2.28. Replacement of the fuel filter
      2.2.29. Level of liquid of system of adjustment of height of a back suspension bracket (91 g of century)
      2.2.30. Replacement of the paper filter
      2.2.31. Check of a sheeting of the bottom of a body
      2.2.32. Check of level of AKPP liquid
      2.2.33. Check of level of liquid of the main transfer (model with AKPP)
      2.2.34. Check of level of MKPP oil
      2.2.35. Each 60 000 km of run
      2.2.36. Replacement of the air filter
      2.2.37. Level of liquid of system of adjustment of height of a back suspension bracket (from 92 g of century)
      2.2.38. AKPP liquid replacement
      2.2.39. Replacement of a gas-distributing belt
      2.2.40. Replacement of a driving belt of the injecting pump (5 TsD)
      2.2.41. Each 2 years
      2.2.42. Replacement of brake liquid
      2.2.43. Replacement of cooling liquid
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


2.2.22. Car check in road conditions


1. Examine shock-absorbers on existence of traces of leakage of liquid. If leak is present, it is necessary to replace the shock-absorber.
2. Check efficiency of shock-absorbers, having shaken the car up-down.

Check steering and suspension bracket work. Check, that at movement there was no vibration or noise.


Check operation of the engine, coupling, a transmission and semi-axes. Check, that at movement they did not publish unusual noise.


1. Check, that the car did not pull aside when braking, and blocking wheels did not occur too early.
2. Check, that the steering wheel did not shiver when braking.
3. Check operation of the hand brake and a servoamplifier of brakes. For this purpose squeeze out a brake pedal several times and start the engine. The pedal should fall a little. Let's to the engine work some minutes and muffle it. Press a brake pedal. You should hear hissing of the vacuum amplifier. After several pressing it should stop, and the pedal to become much more rigid.