Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
- 2. Maintenance
   + 2.1.2. Regular maintenance
   - 2.2. Models with diesel engines
      2.2.2. Regular maintenance
      2.2.3. Each 15 000 km of run
      2.2.4. Replacement of engine oil and filter
      2.2.5. Check of brake overlays of forward brakes
      2.2.6. Check of drain channels before a windshield
      2.2.7. Liquid plums from the fuel filter
      2.2.8. Dumping of indications of the sensor of maintenance
      2.2.9. Each 12 months
      2.2.10. Check of stekloomyvatel
      2.2.11. Check of adjustment of headlights of head light
      2.2.12. Greasing of loops and locks
      2.2.13. Check of level of electrolit in the accumulator
      2.2.14. Check of the module of memory of EBU
      2.2.15. Check on existence of leaks
      2.2.16. Verification of the content of antifreeze
      2.2.17. Check and replacement of maple driving belts
      2.2.18. Check of brake system
      2.2.19. Check of system of production of the fulfilled gases
      2.2.20. Check of elements of a steering, suspension bracket and semi-axes
      2.2.21. Check of a gas-distributing belt (the 4-cylinder engine)
      2.2.22. Car check in road conditions
      2.2.23. Each 30 000 km of run
      2.2.24. Check and greasing of the mechanism of the top hatch
      2.2.25. Check and replacement of a multiband driving belt
      2.2.26. Check of a gas-distributing belt (the 5-cylinder engine)
      2.2.27. Check of a driving belt of the injecting pump (the engine of 2,5 l)
      2.2.28. Replacement of the fuel filter
      2.2.29. Level of liquid of system of adjustment of height of a back suspension bracket (91 g of century)
      2.2.30. Replacement of the paper filter
      2.2.31. Check of a sheeting of the bottom of a body
      2.2.32. Check of level of AKPP liquid
      2.2.33. Check of level of liquid of the main transfer (model with AKPP)
      2.2.34. Check of level of MKPP oil
      2.2.35. Each 60 000 km of run
      2.2.36. Replacement of the air filter
      2.2.37. Level of liquid of system of adjustment of height of a back suspension bracket (from 92 g of century)
      2.2.38. AKPP liquid replacement
      2.2.39. Replacement of a gas-distributing belt
      2.2.40. Replacement of a driving belt of the injecting pump (5 TsD)
      2.2.41. Each 2 years
      2.2.42. Replacement of brake liquid
      2.2.43. Replacement of cooling liquid
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

2.2.17. Check and replacement of maple driving belts

GENERAL INFORMATION

Removal of a maple belt on the 4-cylinder engine

1. Adjusting nut

2. Lock bolt

3, 5, 6. Bolts

4. Nut

PERFORMANCE ORDER

1. Examine driving belts on existence of cracks, attritions, gaps and office of layers.

2. For check of a tension of a belt press with average force on a belt in the middle between two pulleys and measure a belt deviation.

3. For adjustment of a tension of a driving belt turn off fixing bolts of the pump of system of the hydraulic booster of a steering and an adjusting nut and tighten up an adjusting bolt.

4. For belt replacement, turn off fixing bolts and weaken a belt tension.