Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
- 2. Maintenance
   + 2.1.2. Regular maintenance
   - 2.2. Models with diesel engines
      2.2.2. Regular maintenance
      2.2.3. Each 15 000 km of run
      2.2.4. Replacement of engine oil and filter
      2.2.5. Check of brake overlays of forward brakes
      2.2.6. Check of drain channels before a windshield
      2.2.7. Liquid plums from the fuel filter
      2.2.8. Dumping of indications of the sensor of maintenance
      2.2.9. Each 12 months
      2.2.10. Check of stekloomyvatel
      2.2.11. Check of adjustment of headlights of head light
      2.2.12. Greasing of loops and locks
      2.2.13. Check of level of electrolit in the accumulator
      2.2.14. Check of the module of memory of EBU
      2.2.15. Check on existence of leaks
      2.2.16. Verification of the content of antifreeze
      2.2.17. Check and replacement of maple driving belts
      2.2.18. Check of brake system
      2.2.19. Check of system of production of the fulfilled gases
      2.2.20. Check of elements of a steering, suspension bracket and semi-axes
      2.2.21. Check of a gas-distributing belt (the 4-cylinder engine)
      2.2.22. Car check in road conditions
      2.2.23. Each 30 000 km of run
      2.2.24. Check and greasing of the mechanism of the top hatch
      2.2.25. Check and replacement of a multiband driving belt
      2.2.26. Check of a gas-distributing belt (the 5-cylinder engine)
      2.2.27. Check of a driving belt of the injecting pump (the engine of 2,5 l)
      2.2.28. Replacement of the fuel filter
      2.2.29. Level of liquid of system of adjustment of height of a back suspension bracket (91 g of century)
      2.2.30. Replacement of the paper filter
      2.2.31. Check of a sheeting of the bottom of a body
      2.2.32. Check of level of AKPP liquid
      2.2.33. Check of level of liquid of the main transfer (model with AKPP)
      2.2.34. Check of level of MKPP oil
      2.2.35. Each 60 000 km of run
      2.2.36. Replacement of the air filter
      2.2.37. Level of liquid of system of adjustment of height of a back suspension bracket (from 92 g of century)
      2.2.38. AKPP liquid replacement
      2.2.39. Replacement of a gas-distributing belt
      2.2.40. Replacement of a driving belt of the injecting pump (5 TsD)
      2.2.41. Each 2 years
      2.2.42. Replacement of brake liquid
      2.2.43. Replacement of cooling liquid
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

2.2. Models with diesel engines

2.2.1. Introduction

GENERAL INFORMATION

Impellent compartment of models with the diesel 4-cylinder engine in volume of 1,9 l with a turbo-supercharging

1. Cover of a jellied mouth of oil
2. Sensor of a stream of air
3. air filter
4. Valve of system of a retsirkulyatsiya of exhaust gases
5. Top fastening of a rack of a forward suspension bracket
6. Tank of brake liquid
7. An air branch pipe from turbokompressor
8. Fuel filter
9. Broad tank of system of cooling
10. Tank of system of the hydraulic booster of a steering
11. A tank of washing liquid
12. ABS module
13. Shchup for check of level of oil
14. Water pump
15. Generator

The bottom view of an impellent compartment of models with дизельны the 4-cylinder engine in volume of 1,9 l with a turbo-supercharging

1. Reception pipe of an exhaust system
2. Bottom lever of a forward suspension bracket
3. Stabilizer of cross-section stability of a forward suspension bracket
4. Brake support
5. Horns of a sound signal
6. Intermediate cooler
7. Lever of fastening of the engine

8. Generator
9. Cap of a drain opening of the oil pallet
10. Pump of system of the hydraulic booster of a steering
11. Semi-axis
12. Mechanical transmission
13. Oil filter


Impellent compartment of models with the diesel 5-cylinder engine in volume of 2,5 l

1. Cover of a jellied mouth of oil
2. Inlet collector
3. Sensor of a stream of air and air filter
4. Valve of system of a retsirkulyatsiya of exhaust gases
5. Vacuum chamber
6. Top fastening of a rack of a forward suspension bracket
7. Tank of brake liquid
8. A driving belt of the injecting pump

9. The injecting pump
10. Shchup for check of level of oil
11. Accumulator
12. Broad tank of system of cooling
13. Tank of system of the hydraulic booster of a steering
14. A tank of washing liquid
15. ABS module
16. Pump of system of the hydraulic booster of a steering

The bottom view of an impellent compartment of models with the diesel 5-cylinder engine in volume of 2,5 l

1. Reception pipe of an exhaust system
2. Bottom lever of a forward suspension bracket
3. Stabilizer of cross-section stability
4. Brake support
5. Horns of a sound signal
6. Intermediate cooler
7. Lever of fastening of the engine
8. Oil filter
9. Cap of a drain opening of the oil pallet
10. Pump of system of the hydraulic booster of a steering
11. Semi-axis
12. Cap of a drain opening of a mechanical transmission

Bottom view of a back part of a body

1. Intermediate exhaust silencer
2. Longitudinal lever of a back suspension bracket
3. Rope of the hand brake
4. Rack of a back suspension bracket and spring
5. Back axis
6. Cross-section draft
7. Fuel tank
8. Exhaust pipe and exhaust silencer

Carrying out maintenance according to the provided plan of maintenance will provide long and reliable service of the car. This plan of maintenance is full therefore it is recommended to perform all operations of maintenance at the appointed time.

At car service you will notice that some operations can be combined with carrying out other operations is follows from essence of operations of maintenance. For example, if you lifted the car for carrying out any operation, elements of system of production of the fulfilled gases can be checked at the same time with check of elements of a suspension bracket or a steering.

Before the beginning of work it is necessary to be prepared for carrying out maintenance. Read all description of operation which you are going to execute, and get necessary tools and spare parts. If you faced a serious problem, address to experts.

 
Volumes
Models
with the 4-cylinder engine
Models
with the 5-cylinder engine
Engine oil (including the filter)
3,0 l
5,0 l

Cooling system:
  – all models
6,5 l

Transmission:
  – mechanical transmission
2,4 l
  – automatic transmission:
     • total amount
5,5 l
     • liquid replacement
3,5 l
     • main transfer of an automatic transmission
1,0 l
System of the hydraulic booster of a steering:
  – models with automatically adjustable back suspension bracket
2,5 l
  – models with a usual back suspension bracket
1,1 l
Fuel tank:
  – all models (approximately)
80 l
Engine:
  – oil filter:
     • models with the engine 1Z AHU coding
Champion C150
     • models with the AAT engine coding (the A6 models with a mechanical transmission)
Champion C150
     • models with the engine ABP, AAT coding (to the Audi 100 VIN 4A-N-250-000 models
Champion C 150
     • models with the AAT engine coding (the A6 models with a mechanical transmission), AEL
Champion C 152
     • models with kodirosky the engine AEL, AAS
Champion C 152
     • models with kodirosky the AAT engine (since the Audi 100 VIN 4A-P-000-001 models)
Champion C 112
Cooling system:
  – content of antifreeze:
     • 40 % content of antifreeze
Protection to–25 ° With
     • 50 % content of antifreeze
Protection to–35 ° With
Power supply system:
  – air filter:
     • models with the engine 1Z, AHU coding
Champion U 572
     • all other models
Champion U 633
  – fuel filter:
     • models with the coding of the engine 1Z, AHU, ABP, AAT (A6 model), AEL
Champion L 114
     • models with the coding of the AAT engine (Audi 100 model)
Champion L 118
     • models with the AAS engine coding
Champion L 117
Brake system:
  – minimum admissible thickness of brake slips
2,0 mm
  – minimum admissible thickness of a frictional material of brake shoes
2,5 mm
  – minimum admissible thickness of a frictional material of brake shoes of back brakes
2,5 mm
Driving belt:
Deviation of a maple driving belt (engines 1Z and AHU)
5,0 mm

Moments of an inhaling, N of m.
Fixing bolt of the generator
35
Fastening of a natyazhitel of the generator
20
Nut of fastening of a natyazhitel of the generator
35
Nut of fastening of a jellied tube of an automatic transmission (097)
80
Cap of a jellied opening / opening for check of level of liquid of an automatic transmission
25
Cap of a viewing opening of an automatic transmission (01N)
15
Perepuskny tube of an automatic transmission (01N)
2
Bolt of fastening of the fuel filter (the 5-cylinder engine)
25
Cap of a jellied opening / opening for check of level of oil of a mechanical transmission:
  – transmission 012
25
  – transmission 01Е
40
Fastening of the pump of system of the hydraulic booster of a steering
25
Bolts of fastening of wheels
110
Cap of a drain opening of the oil pallet
30