Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
- 2. Maintenance
   - 2.1.2. Regular maintenance
      2.1.3. Each 15 000 km of run
      2.1.4. Replacement of engine oil and filter
      2.1.5. Check of brake overlays of forward brakes
      2.1.6. Check of drain channels before a windshield
      2.1.7. Dumping of indications of the sensor of maintenance
      2.1.8. Each 12 months
      2.1.9. Check of stekloomyvatel
      2.1.10. Check of adjustment of headlights of head light
      2.1.11. Greasing of loops and locks
      2.1.12. Check of level of electrolit in the accumulator
      2.1.13. Check of the module of memory of EBU
      2.1.14. Check on existence of leaks
      2.1.15. Verification of the content of antifreeze
      2.1.16. Replacement of spark plugs (model on etilirovanny gasoline)
      2.1.17. Check and replacement of maple driving belts
      2.1.18. Check of brake system
      2.1.19. Check of system of production of the fulfilled gases
      2.1.20. Check of elements of a steering, suspension bracket and semi-axes
      2.1.21. Each 30 000 km of run
      2.1.22. Check and greasing of the mechanism of the top hatch
      2.1.23. Replacement of spark plugs (model till 1993 of century, unleaded gasoline)
      2.1.24. Level of liquid of system of adjustment of height of a back suspension bracket (91 g of century)
      2.1.25. Check and replacement of a multiband driving belt
      2.1.26. Replacement of the fuel filter
      2.1.27. Replacement of the paper filter
      2.1.28. Check of a sheeting of the bottom of a body
      2.1.29. Check of level of AKPP liquid
      2.1.30. Check of level of liquid of the main transfer (model with AKPP)
      2.1.31. Check of level of MKPP oil
      2.1.32. Each 60 000 km of run
      2.1.33. Replacement of the air filter
      2.1.34. Replacement of spark plugs (model since 1994 of century)
      2.1.35. Level of liquid of system of adjustment of height of a back suspension bracket (from 92 g of century)
      2.1.36. Replacement of a driving belt (4-cylinder engines)
      2.1.37. AKPP liquid replacement
      2.1.38. Replacement of a gas-distributing belt
      2.1.39. Each 2 years
      2.1.40. Replacement of brake liquid
      2.1.41. Replacement of cooling liquid
   + 2.2. Models with diesel engines
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

2.1.16. Replacement of spark plugs (model on etilirovanny gasoline)

GENERAL INFORMATION

The correct work of spark plugs is very important for effective operation of the engine.

PERFORMANCE ORDER

1. Turn off fixing screws and remove a casing from a cover of the klapanny mechanism.
2. Mark wires of a high voltage and disconnect them from spark plugs.
3. Clear area round spark plugs and unscrew candles.
4. Negative wire of the storage battery and "mass" wire of the engine.

5. Measure a spark gap of a candle by means of a set щупов or the special tool.
	6. Adjust it, having turned in a tip.
7. Establish spark plugs into place. For simplification of installation of spark plugs, put on a short piece of a tube a candle. It will represent itself as the universal hinge and will not allow to damage a carving.