| 1. Remove a protective casing of a fuel tank and disconnect ropes of the hand brake. |
|
2. Disconnect brake tubes and remove ropes, wires and brake tubes from fastenings on a cross-piece.
|
| 3. Check, that all elements were disconnected and did not disturb cross-piece removal. |
|
4. Turn off fixing nuts and the bolts, fixing racks of a suspension bracket to a cross-piece. |
| 5. Turn off fixing bolts of a support and remove a support from a rack. |
| 6. Turn off a fixing nut and remove a bolt, fixing cross-section draft in a suspension bracket cross-piece. |
|
7. Turn off and remove sharnirny bolts and remove a cross-piece. |
|
8. Examine plugs of fastenings and replace them if it is necessary. At installation of plugs check, that the central line B between cuts was at an angle 90 °±4 ° to an axis of longitudinal draft And. |
