Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
- 11. Suspension brackets, steering
   11.2. Technical characteristics
   11.3. General description of adjustment of wheels
   + 11.4. Forward suspension bracket
   - 11.5. Back suspension bracket
      11.5.2. Bearings of a nave of a back wheel
      11.5.3. Pin of a back wheel
      11.5.4. Rack of a back suspension bracket
      11.5.5. Cross-section draft of a back suspension bracket
      11.5.6. Stabilizer of cross-section stability of a back suspension bracket
      11.5.7. Cross-piece of a back suspension bracket
      11.5.8. System of adjustment of height of a back suspension bracket
      11.5.9. Elements of system of adjustment of height of a back suspension bracket
   + 11.6. Steering
   + 11.7. Semi-axes
   11.8. Easily and easy
   11.9. Maintenance of system of a steering
   11.10. Diagnostics of malfunctions of system of a steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

11.5.4. Rack of a back suspension bracket

Removal

PERFORMANCE ORDER

1. Remove the corresponding wheel.
2. Disconnect a hydraulic tube from a suspension bracket rack if it is necessary.
3. Establish a jack under a back axis.
	4. Turn off a fixing nut and remove a bolt, fixing a rack to a back axis.
	5. Turn off nuts of the top fastening and remove a rack.

Installation

Installation is carried out upside-down removals.

Repair

PERFORMANCE ORDER

1. Remove a rack and clear it. Mark the provision of installation of a fixing plate, a spring, the bottom saddle and the shock-absorber.
2. Compress a spring by means of compressors.
3. Turn off a fixing nut and remove the plug, a fixing plate, the top saddle and a spring.
4. Remove connection of a hydraulic tube if it is necessary, then remove a washer, an emphasis, the protective plug, a cap and the bottom saddle of a spring.
5. Examine the shock-absorber on existence of leak or damages and check its work.
	6. Collecting it is carried out upside-down. At assembly of a rack check, that the emphasis on the bottom saddle of a spring (it is specified by an arrow) was established at an angle in 90 ° to an axis of the bottom fixing bolt.