Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
- 11. Suspension brackets, steering
   11.2. Technical characteristics
   11.3. General description of adjustment of wheels
   - 11.4. Forward suspension bracket
      11.4.2. Rack of a forward suspension bracket
      11.4.3. Shock-absorbers of a forward suspension bracket
      11.4.4. Bottom lever of a forward suspension bracket
      11.4.5. Stabilizer of cross-section stability of a forward suspension bracket
      11.4.6. Cross-piece of a forward suspension bracket
   + 11.5. Back suspension bracket
   + 11.6. Steering
   + 11.7. Semi-axes
   11.8. Easily and easy
   11.9. Maintenance of system of a steering
   11.10. Diagnostics of malfunctions of system of a steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

11.4.2. Rack of a forward suspension bracket

Removal

PERFORMANCE ORDER
1. Weaken a fixing bolt of a nave.
2. Turn off fixing bolts and the nuts, fixing the stabilizer of cross-section stability to a body.
3. Remove a wheel and a bolt of fastening of a nave. Remove the wheel sensor if it is necessary (on models from ABS).
4. Turn off fixing bolts of a support and remove a support from a rack.
5. Disconnect the spherical hinge of steering draft from a rack.
6. Turn off a nut and remove a fixing bolt of fastening of the lever of a suspension bracket to a rack.
7. Disconnect the spherical hinge of the lever of a suspension bracket from a rack.
8. Remove a casing, turn off nuts of the top fastening (two nuts are specified by shooters) and remove a rack from the car.

Installation

Installation is carried out upside-down removals.

PERFORMANCE ORDER
1. Establish washers and new nuts.
2. Tighten fixing nuts till the demanded moment of an inhaling.

Repair

PERFORMANCE ORDER
1. Remove a rack from the car and establish compressors of springs.
2. Turn off a nut on a rod of the piston of the shock-absorber.
3. Remove a nut and a washer.
4. Remove a fixing plate and laying (it is specified by an arrow).
5. Remove the plug and the top saddle of a spring.
6. Remove a spring, пыльниу and a rubber emphasis (it is specified by an arrow).
7. By means of the special tool 1 turn off a fixing cap 2 and remove the shock-absorber.
8. Check the shock-absorber on existence of damages and leak traces. Check operation of the shock-absorber. Replace worn-out elements of a rack.
9. Establish the bottom end of a spring in deepening in a saddle. Establish the top saddle on a place and put on a boot a saddle edge.
10. Establish laying on the top saddle, combine cuts on laying with heads of bolts (are specified by shooters).
11. Before removal of compressors of a spring check, that the ends of a spring concerned an emphasis.