Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
- 7. Exhaust system
   7.2. Technical characteristics
   7.3. Collecting system паров fuels
   + 7.4. System of collecting karterny gases
   + 7.5. System of a retsirkulyatsiya of exhaust gases
   7.6. Final collector
   7.7. urbokompressor
   7.8. Intermediate cooler
   7.9. System of production of the fulfilled gases
   7.10. Catalytic converter
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

7.7. Turbokompressor

GENERAL INFORMATION

Turbokompressor is established on a final collector and includes perepuskny the valve and a vacuum diaphragm. Turbokompressor uses oil greasing.

Giving tube oils (engine 1Z)

Removal

PERFORMANCE ORDER

1. Remove a protective guard from below an impellent compartment.

2. Turn off fixing nuts and disconnect a reception pipe of an exhaust system.

3. Lift the receiver supply of oil of a turbokompressor (AAT engine).

4. Disconnect an air hose from a turbokompressor (AAT engine).

5. Disconnect a tube of the return pipeline (AAT engine).

6. Cнимите a tube of the return pipeline from the engine.

7. Disconnect a vacuum hose from the turbokompressor valve (on fig. at the left – the AAT engine, on the right – 1Z).

6. Turn off fixing nuts and remove a turbokompressor.

Installation

Installation is carried out upside-down removals.