Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
- 3.3. Removal and partition of engines
   + 3.3.2. Technical characteristics
   3.3.3. Repair work, possible without engine dismantle
   + 3.3.4. Major maintenance
   3.3.5. Removal and engine installation
   3.3.6. Engine partition
   + 3.3.7. Head of cylinders
   3.3.8. Pistons and rods
   + 3.3.9. Cranked shaft
   3.3.10. Intermediate shaft
   3.3.11. Block of cylinders
   3.3.12. Radical bearings and bearings of rods
   3.3.13. Piston rings
   3.3.14. The first start of the engine after a partition
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

3.3.13. Piston rings

Installation

PERFORMANCE ORDER

1. Before installation it is necessary to check trailer and lateral gaps of piston rings.
2. Establish the top kompressionny ring in the cylinder by means of the piston.
	3. Measure a trailer gap of a ring with the help щупа. If a gap too small, replace piston rings.
4. Carry out similar procedure with all rings.
	5. After check and adjustment of a trailer gap, a ring it is possible to establish on pistons. In drawing – a label on the top party of a piston ring.
6. The maslosjemny ring is established to the first. At first establish a broad ring in a flute, then establish the bottom and top maslosjemny rings.
7. After installation of all elements of a maslosjemny ring check, that the top and bottom rings rotated freely.
8. Establish the second kompressionny ring a mark up.
9. Then establish the top kompressionny ring.