Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   + 6.1.2. Technical characteristics
   + 6.2. Multipoint system of injection of fuel
   + 6.3. System of injection of MPI/MPFI (6-cylinder engines)
   - 6.4. Power supply system of diesel engines
      6.4.2. Technical characteristics
      6.4.3. Air filter
      6.4.4. Rope of an accelerator and elements of a pedal of an accelerator
      6.4.5. Fuel level sensor
      6.4.6. Fuel tank
      + 6.4.7. The injecting pump
      6.4.8. Speed of idling and maximum speed of operation of the AAS engine
      6.4.9. Mode of fast idling (AAS engine)
      6.4.10. Residual volume of fuel (AAS engine)
      6.4.11. Fuel injectors
      6.4.12. Control system of operation of the diesel engine
      6.4.13. Inlet collector
   6.5. Device of service of heating
   6.6. Diagnostics of malfunctions of system of heating
   6.7. Conditioner: not only "pluses", but also "minuses"
   6.8. Rules of service of the conditioner
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

6.4.4. Rope of an accelerator and elements of a pedal of an accelerator

ROPE OF THE ACCELERATOR (AAS)

Removal

PERFORMANCE ORDER
1. Remove the panel of furnish and disconnect a rope from a pedal.
2. In an impellent compartment remove a fixing clip and disconnect a rope from the lever.
3. Remove a rope from the car.

Installation and adjustment

PERFORMANCE ORDER
1. Installation is carried out upside-down removals. Adjust a rope tension so that the throttle lever concerned an emphasis by pressing an accelerator pedal.

ACCELERATOR ROPE WITH MECHANICAL ADJUSTMENT (AAS ENGINE)

Removal

PERFORMANCE ORDER
1. Turn the adjusting handle up to the end counter-clockwise.
2. Disconnect a rope from the lever and remove it from the car.

Installation

Installation is carried out upside-down removals.

ACCELERATOR ROPE (EXCEPT AAS ENGINES)

Removal

PERFORMANCE ORDER
1. Remove the furnish panel.
2. Disconnect a rope from a pedal.
3. Turn off a nut, remove a washer and disconnect a rope from the sensor of provision of a pedal. Remove a rope.

Installation

Installation is carried out upside-down removals.